Hendi 207345 Mode D'emploi page 5

• Caution! Securely route the power cord if necessary in order to prevent unintentional
pulling or contact with the heating surface.
• Do not wash the appliance with water. Washing can cause leakages and increase the risk
of electric shock.
• Do not clean or store the appliance unless it is completely cooled down.
• No part is dishwasher safe.
• Always remove the plug from the socket when filling or cleaning the deep fryer.
• The electrical installation must satisfy the applicable national and local regulations.
• The Fryer tank and element should be placed in a safe position in your kitchen before
usage due to the hot contents when in use.
• To avoid the risk of fire, do not allow the oil level to drop below the L- mark (MIN level).
Always use plenty of oil in the oil container.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and
a soft cloth.
Installation
• Place the appliance on a level, stable, clean,
heat-resistant and dry surface with its rubber
feet.
• Carefully install the back support with heating el-
ement on the rear edge of the oil container.
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
Note:
1. Make sure that the pin on the back support is in
the correct position & properly mounted.
2. The appliance should be placed in a safe posi-
tion in your kitchen before use due to hot hazard
when in use.
EN
5