Publicité
2. Lift pullout lock and pull clean-out port knob to empty
ash into ash cup. See Fig 13
3. See instructions for burner clean-out.
Hopper Clean-out Knob Assembly Installation
Hand tighten the hopper clean-out knob as shown in Fig 14.
PG24-9 (1)
PULLOUT KNOB
FIG.14
Probe
1. Plug the Meat Probe into the Probe receptacle on the
control panel. Run the probe and wire through the probe
access hole on the side of the grill. See Fig 15.
2. See instructions for Meat Probe.
PROBE
FIG.13
CLEANOUT PORT OPEN
PROBE HOLE
FIG. 15
https://manual-hub.com/
Burner Clean-out
Before each use the burner should be cleaned out by lifting
the pullout lock and pulling the clean-out port knob on the
right side of the grill to open the burner clean-out. This will
allow the ash from previous use to fall into the cup under
the grill. The cup should be removed and emptied and then
reinstalled before each use.
Never Operate the Pellet grill without the ash cup in place.
Make sure the burner clean-out port is closed and locked
before starting the grill.
Never open the burner clean-out port when the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right
side of the grill. Make sure to lift the pullout lock and push
the clean-out port knob all the way in and lock in place
with the pullout lock. Every 50 hours of use, remove the grill
grates, grease tray, and heat deflector and clean the inside of
the grill. If you notice a lot of ash blowing around in the grill
it is time to vacuum it out.
Filling the Auger Tube
Caution: Only use the feed setting when hopper has run
out of pellets. Feed setting is not for normal use.
The first time you use your grill or any time the hopper has
run out of pellets you will need to fill the auger tube. This
simply means you must fill the auger tube with pellets until
pellets reach the burner. This is done by selecting FEED from
the main menu: With the controller powered on press the
selector knob to enter the MENU. Rotate the knob until FEED
is shown and press the selector knob again. This will turn
the auger on and the controller will display "FEED" and a
countdown timer. The auger will remain on for no more than
7 minutes. This is ample time for the pellets to reach the
burner. To avoid over-filling of the burner with pellets, open
the burner clean-out by pulling the knob on the right side of
the grill, opening the clean-out slide. Once you hear pellets
dropping into the ash cup you can close the clean-out by
pushing the knob on the right side of the grill. FEED mode
DANGER
Publicité
