Assembly Instructions
Remove all loose parts from the inside of the grill and
hopper. Lay a blanket or piece of cardboard down to protect
the grill.
Attach the Legs
With the help of another person flip the grill upside down
on the blanket or cardboard. The grill lid and hopper lid will
swing open when doing this so be careful not to damage
the lids. The grill may also want to roll on its lid so one
person should hold the grill steady while the other person
assembles the bottom legs and wheels.
1. Lay the grill on its back.
2. Install each of the 4 legs as shown in Fig 1. Make sure
the legs with wheels are attached to the right side of
the grill with the wheels facing out. Note: Front legs are
marked with an F and back legs are marked with a B.
3. Stand the grill upright
4. Tighten all hardware.
Attach Chimney and Chimney Cap
1. Install chimney to grill as shown in Fig 2. Make sure to
install the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install 1/4 -20 x 3 Bolt through chimney cap and secure
using Qty (1) 1/4 -20 nut. Thread second nut onto bolt
leaving approximately 1.5" to the top of the cap. Thread
cap assembly down into the chimney bracket until the
lower nut hits the bracket. See Fig 2.
4. The height of the chimney cap can be adjusted for
summer and winter. In the summer the gap should be
approximately 1-1/2". In the winter the gap should be
approximately ½".
5. Tighten all hardware.
1/4-20 x 3 BOLT (1)
1/4-20 NUT (2)
M6 X 15 SCREW
CHIMNEY GASKET
Install Handle
1. Install the handle as shown in figure 3.
2. Tighten all hardware.
FIG. 3
M8 X 20 BOLT
M8 LOCK WASHER
Install Hopper Handle
1. Install hopper handle as shown in Fig. 4.
FIG. 1
Install Hopper Lid
1. Install hopper lid as shown in Fig. 5.
HOPPER LID (1)
M4 X 10 SCREW (2)
FIG. 5
https://manual-hub.com/
PG24-57 (1)
HANDLE
PG24-71 (2)
HANDLE BEZEL
PG24-58 (1)
HANDLE DEFLECTOR
PG24-59 (2)
M6 HANDLE SCREW
HOPPER HANDLE (1)
PGC24-12
M6 RUBBER WASHER (2)
M6 FENDER WASHER (2)
M6 LOCK WASHER (2)
M6 X 15 BOLT (2)
FIG. 2
FIG. 4