Publicité
DMX TABLE
CH1
0~255
CH2
0~255
CH3
0~255
CH4
0~255
CH5
11~255
11~50
51~100
101~150
CH6
151~200
201~250
251~255
CH7
0~255
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems have
to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure that the light is power off before dismantling or maintaining, it's very important to keep the light clean.
Frequent cleaning will ensure maximum brightness output, but also prolong the life time. It's suggested to use the high
quality, professional glass detergent and soft cloth to clean the light. It's not allowed to use alcohol or chemical solvent.
The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced, find
out the faulty and restart the light. But please note the repair must be handled by professional.
© Copyright LOTRONIC 2012
All manuals and user guides at all-guides.com
Red
Green
Blue
White
LED Strobe（From slow to fast）
Auto1 DMX (Strobe)
Auto2 DMX (No Strobe)
Gradual change
Auto3 DMX (
Sound1 DMX (Strobe)
Sound2 DMX (No Strobe)
Gradual change
Sound3 DMX (
Auto DMX/ Sound DMX Speed (Slow--Fast)
STROBE RGBW LED PRO
)
)
Page 5
Publicité
