Laerdal ALS Baby Trainer Mode D'emploi page 7

Laerdal ALS Baby direction for use rev E:Laerdal ALS Baby dire#88E7D.qxd
- Unsnap the two lung
connectors.
- Unsnap the silicone stomach
tube from the oesophagus
end of the head/
airway assembly.
- Discard lung/stomach.
To install
- Unpack new lung/stomach (Cat. No. 08 20 25).
- Connect stomach tube to oesophagus end of head/
airway assembly.
- Place new airway/stomach with the lung connectors into
the two holes in the chest plate.
- Connect the two lung tubes to the two lung connectors
in chest plate.
- Mount the stomach pressure valve band over the
two tabs. Put chest plate in place over the chest
compression slide.
- Put chest skin back on. Make sure the cables are
placed inside the chest skin so that they do not restrict
chest movement.
Cleaning upper airways
To remove
- Open up manikin and disconnect airway/stomach as
described in "To remove" in section "Replacing the
lungs/stomach".
- Press down tab on inner
neck connector and pull
head away from body.
- Remove face skin as described in "To remove"
in section "Replacing or cleaning the face skin".
27.03.2009
To clean
- Open and empty the cleaning kit basin.
- Place the manikin head face
down in the cleaning basin.
- Connect the two lung tube
connectors to the double
Y-piece in the tube system.
- Connect the oesophagus
to the single connection
in the tube system.
- Insert the cleaning syringe into the valve opening
and place the free end of the tube system into the basin.
- Fill the basin with liquid to just
underneath the edge. Circulate
liquid through the manikin airways
by pumping the syringe plunger.
- Use this setup to go through
the following steps:
1: Use a Disinfectant solution*. Airways should remain
completely filled for at least 10 minutes.
2: Use fresh water to remove disinfectant solution.
After each step lift the head clear of the liquid
to allow drainage.
3: Allow to dry completely before reconnecting head
to manikin.
* Virkon can be used. Depending on local procedures you may prefer to
use a sodium hypochlorite solution freshly prepared for single class use.
This solution should have at least 500 ppm free available chlorine, i.e. 22 ml of 2.5 -
5.0 % household bleach per 500 ml of water. Local cleaning and handling procedures
must be followed.
7
12:14 Page 7