Publicité
4
Safety instructions
Designated use
The force transducers in the type series S2M are solely designed for measur-
ing static and dynamic tensile and/or compressive forces within the load limits
specified by the technical data for the respective maximum capacities. Any
other use is not the designated use.
To ensure safe operation, the regulations in the mounting and operating
instructions, together with the following safety rules and regulations, and the
data specified in the technical data sheets, must be complied with. It is also
essential to observe the applicable legal and safety regulations for the applic-
ation concerned.
The force transducers are not intended for use as safety components. Please
also refer to the section: "Additional safety precautions". Proper and safe
operation of force transducers requires proper transportation, correct storage,
siting and mounting, and careful operation.
Loading capacity limits
The data in the technical data sheet must be complied with when using the
force transducer. In particular, the respective maximum loads specified must
never be exceeded. The following limits set out in the technical data sheets
must not be exceeded
Limit loads
Lateral load limits
Breaking loads
Permissible dynamic loads
Temperature limits
Limits of electrical loading capacity
Please note that when several force transducers are interconnected, the load
/force distribution is not always uniform.
Use as a machine element
The force transducers can be used as machine elements. When used in this
manner, it must be noted that, to favor greater sensitivity, the force transducer
was not designed with the safety factors usual in mechanical engineering.
Please refer here to the section "Loading capacity limits" and to the specifica-
tions.
HBM
S2M
A3592-1.1 en/de/fr
Publicité
