Publicité
Safety / Start-up
maintenance must not be performed by children
without supervision.
RISK OF INJURY!
Do not leave the lamp or the packaging material
■
lying around. Plastic foils, bags, parts, etc. can
become dangerous toys in the hands of children.
Avoid the risk of fatal injury from
electric shock
Always check the light, power supply, and mains
■
cable for damage before plugging it in. Never use
the light if it shows any signs of damage.
A damaged mains cable indicates a life-threatening
■
danger due to electric shock. In the event of
damage, repairs or other problems with the light
please contact the service centre or a qualified elec
trician.
Ensure that the light does not come into contact with
■
water or other liquids under any circumstances.
Never open any of the components of the electrical
■
equipment or insert any objects into the same
components. This will pose a risk of fatal injury from
electric shock.
Only hold the insulated section of the power plug
■
when connecting to or disconnecting from the mains
current!
The outer flexible cable of this lamp cannot be
■
replaced; if the cable is damaged, the lamp must be
disposed.
Before use, make sure that the available mains
■
voltage matches the required operating voltage of
the lamp (see "Technical data").
Always pull the power cable out of the socket
■
before assembling, dismantling or cleaning the lamp
or if you are not going to use the lamp for a while.
Do not place the lamp on a damp or conductive
■
surface.
Lamp - use only in a dry environment.
■
Not suitable for external dimmers or
■
electronic switches.
Safe working
16
GB/IE
Place the lamp in a location where it is protected
■
from moisture and dirt.
Always be attentive! Always pay attention to what
■
you are doing and use common sense. Never install
the light if you are having difficulty concentrating or
do not feel well.
Do not cover the lamp with cloths, curtains or other
■
objects and keep away from other easily combus
tible materials. Ensure sufficient air circulation and
distance around the lamp. Excessive heat develop
ment can lead to fire.
The power cable is not a carrier handle.
■
Do not look into the illuminant at a close distance
■
during operation.
Do not look at the LED with an optical instrument
■
(e.g. magnifying glass).
Remove the power plug from the socket to discon
■
nect the lamp from the power supply.
Only use the type of illuminant stated in the "Tech
■
nical data" section.
● Start-up
● Mounting the lamp
Note: Remove all packaging material from the product.
Assemble three parts of the legs 10 by screwing
□
them into each other.
Screw the 3 legs 10 to the lamp.
Put the cable guides 12 on one leg 10 and insert
the power cable 11 into the cable guides 12 .
Turn the diffuser sheet 1 into a tube and fix it with
□
the plastic rivets 2 .
Fix the rods 3 to the first base ring (A) 5 with the
□
screws 4 . Make sure that the countersunk holes
for the screw heads on the base ring (A) 5 face
outwards.
Carefully slide the previously created diffuser tube
1
between the rods 3 .
Fix the rods 3 and the diffuser tube 1 with the
second base ring (B) 5 . Be careful not to damage
the diffuser tube 1 and the rods 3 are aligned
straight.
Tighten the screws 4 carefully.
Now insert the slats 6 one after the other into the
□
openings on the sides of the base rings 5 . Make
sure that the slats 6 are straight.
Detach the lamp ring 8 from the fixture 9 .
□
Publicité
