Publicité
6. Third Press ENTER to select EN item. Use +/- to select "ON" to enable the function,
and "OFF" to disable the function.
7. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to
return to the Main Screen.
Example:
ST
L 50%
R 30%
TH
L 20%
R 50%
EN
„ON"
5.12. TH HOLD
This function allows the Throttle Servo to be set to a percentage of the total travel
range. This is an alternative to using the motors choke when starting up the model. Throttle
hold can be performed by pressing the switch to stop the engine. It can be performed
for accident braking. When pressing the switch, throttle trigger doesn't work until the switch
is pressed again.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH HOLD function and press ENTER.
3. Use the +/- Key to change the value.
4 . Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to
return to the Main Screen.
TERMS: VALUE -- Throttle hold position. Range: -120% to +120%.
5.13. FAILSAFE (F/S)
If the RF signal loss, it should occur the receiver adjust the Steering or Throttle or both
to a preset value. The servo value of Steering channel and Throttle channel in the fail
status can be set through fail safe function.
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the F/S function and press ENTER.
3. Press ENTER to select a item.
4. Use the +/- Key to change the value.
5. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to
94003 GM-Racing XG-4i 2.0 FHSS Race Spec
All manuals and user guides at all-guides.com
If throttle servo is 60% on the right and rudder servo is 50% on the right,
and then after setting, throttle servo is: 50*30%+60%*50%=45%. Thrott-
le servo will act along with the action of STEERING servo.
34
Publicité
