Publicité
The cuff must be placed on the
upper arm so that the bottom edge
is positioned 2 – 3 cm above the
elbow and over the artery. The line
should point to the centre of the
palm.
Now tighten the free end of the
cuff, but make sure that it is not
too tight around the arm and close
the hook-and-loop fastener. The
cuff should be fastened so that
two fingers can fit under the cuff.
Now insert the cuff line into the
connection for the cuff connector.
Important: The unit may only be operated with the original
cuff. The cuff is suitable for an arm circumference of 22 to
36 cm.
Adopting the correct posture
All manuals and user guides at all-guides.com
• Before every measurement, relax for about five minutes.
• You can take the measurement while sitting or lying. Al-
• To carry out a blood pressure measurement, make sure
• To avoid falsifying the measurement, it is important to
Performing the blood pressure measurement
• As described above, attach the cuff and adopt the pos-
• Start the blood pressure monitor with the START/STOP
• The cuff automatically inflates. The cuff's air pressure is
• The cuff position control symbol
21
Otherwise deviations can occur.
ways make sure that the cuff is at heart level.
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
remain still during the measurement and not to speak.
ture in which you want to perform the measurement.
button
.
slowly released. If you already recognise a tendency for
high blood pressure, you should reinflate the cuff and
increase the cuff's pressure again. As soon as a pulse is
found, the pulse symbol
throughout the entire measurement. If the cuff is applied
too tightly or too loosely, then
played. In such cases, the measurement is cancelled after
approx. 30 seconds and the device switches itself off.
Apply the cuff correctly and take a new measurement.
will be displayed.
is displayed
and "
" are dis-
Publicité
