DeWalt DW079 Mode D'emploi page 45

Wall Mount (Fig. 3)
aa. Mounting base
bb. Base mounting hole
cc. Mounting knob
dd. Scale
ee. Clamp locking knob
ff. Mounting holes
gg. Base leveling knob
hh. Locking knob
ii. Adjustment knob
electrical safety
The electric motor has been designed for various
voltages (see technical data). Always check that the
battery pack power corresponds to the voltage on
the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your D WALT charger is double insulated
e
in accordance with EN 60335.
In case of cord replacement the tool must only
be repaired by an authorized service agent or by
qualified electrician.
Mains plug replacement
(u.k. & ireland only)
DANGER:
• S hould your mains plug need replacing
and you are competent to do this,
proceed as instructed below. If you are
in doubt, contact an authorized D
repair agent or a qualified electrician.
• D isconnect the plug from the supply.
• C ut off the plug and dispose of it safely;
a plug with bared copper conductors
is dangerous if engaged in a live socket
outlet.
• O nly fit 13 Amperes BS1363A approved
plugs fitted with the correctly rated fuse
(1).
• T he cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to
their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue
is for Neutral (N) (4).
• B efore replacing the top cover of the
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the cable
firmly and that the two leads are correctly
fixed at the terminals crews.
All manuals and user guides at all-guides.com
using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm
When using a cable reel, always unwind the cable
completely.
unpacking
Fitting the WaRning laBel
The safety warnings on the label shown on the laser
must be formulated in the language of the user.
For that purpose, a separate sheet of self-adhesive
labels has been supplied with the tool.
WALT
e
The warnings should read as follows:
• If the warnings are in a foreign language,
asseMBlY
4
3
WARNING: NEVER use a light socket.
NEVER connect the live (L) or
neutral (N) wires to the earth
pin marked E or .
; the maximum length is 30 m.
2
WARNING: Check that the safety
warnings on the label have been
formulated in your language.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 3R LASER PRODUCT
proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing
label.
– Press the label in place.
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
english
1
2
43