Publicité
unauthorized repair or maintenance.
�
Laser maintenance: It is not necessary to
maintain the laser regularly. If the laser
does not work, the laser assembly needs to
be replaced in the factory under warranty.
Keep the device power off when replacing
laser assembly. Caution-Use of controls or
adjustments or performance of procedures
other than those specified herein may
result in hazardous radiation exposure.
Maintenance
�
If the product does not work properly,
please contact your dealer or the nearest
service center. We shall not assume any
responsibility for problems caused by
unauthorized repair or maintenance.
�
Wipe the device gently with a clean cloth
and a small quantity of ethanol, if
necessary.
�
If the equipment is used in a manner not
specified by the manufacturer, the
protection provided by the device may be
impaired.
�
Your camera will periodically perform a
self-calibration to optimize image quality
and measurement accuracy. In this
process the image will pause briefly and
you'll hear a "click" as a shutter moves in
front of the detector. The self-calibration
will be more frequent during start up or in
very cold or hot environments. This is a
normal part of operation to ensure
optimum performance for your camera.
Power Supply
�
Input voltage should meet the Limited
Power Source (5 VDC, 2 A) according to the
IEC62368 standard. Please refer to
technical specifications for detailed
information.
�
Make sure the plug is properly connected to
the power socket.
�
DO NOT connect multiple devices to one
power adapter, to avoid over-heating or fire
hazards caused by overload.
�
Please refer to technical specifications for
detailed information.
Using Environment
�
Make sure the running environment meets
the requirement of the device. The operating
temperature shall be -10 °C to 50 °C (14 °F
to 122 °F), and the operating humidity shall
be 95% or less.
�
Place the device in a dry and well-ventilated
environment.
�
DO NOT expose the device to high
electromagnetic radiation or dusty
environments.
�
DO NOT aim the lens at the sun or any other
bright light.
�
When any laser equipment is in use, make
sure that the device lens is not exposed to
the laser beam, or it may burn out.
�
DO NOT aim the lens at the sun or any other
bright light.
�
The device is suitable for indoor and
outdoor uses, but do not expose it in wet
conditions.
�
The level of protection is IP 54.
Transportation
�
Keep the device in original or similar
packaging while transporting it.
�
Keep all wrappers after unpacking them for
future use. In case of any failure occurred,
you need to return the device to the factory
with the original wrapper. Transportation
without the original wrapper may result in
damage on the device and the company
shall not take any responsibilities.
�
DO NOT drop the product or subject it to
physical shock. Keep the device away from
magnetic interference.
Emergency
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the
power cable, and contact the service center.
Calibration Service
Please contact the local dealer for the
information on maintenance points. For more
detailed calibration services, please refer to
https://www.hikmicrotech.com/en/support
Limited Warranty
Scan the QR code for the product warranty
policy.
054
Publicité
