Publicité
Preparing for use
Q
Note: Remove all packaging materials from the product.
Installing the product
Q
1. Rotate the solar housing
2. Move the ON / OFF switch
the product on.
3. Insert the solar housing
turning it clockwise. Please make sure the solar housing
in correct position, the groove
in lamp shade
4. Take out the ground spike
and insert it into the housing
5. Your product is ready for use.
Setting up the product
Q
I nsert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
M ake sure you keep proper footing and balance at all times.
Do not use any force when assembling or setting-up the prod-
uct, e.g. hammer blows. This will damage the product. In order
to achieve the best result, set the product up in a place where
the solar cell
D o not set the product up under bushes, trees, porches, etc.,
as this will reduce the amount of sunlight it receives.
anticlockwise out of the housing
2
8
into the housing
2
(see fig.).
11
10
9
will get direct sunlight for as long as possible.
1
into the ON position to switch
9
must engage in the recess
6
from bottom of the housing
with the tip facing downwards.
.
9
and tighten by
is
2
3
9
GB/IE
27
Publicité
