Publicité
To connect the battery to the product
WARNING:
original batteries in the product.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it
is not installed correctly.
3. Press the lower part of the battery and
push it in as far as it will go into the
battery compartment. The battery will lock into
position when you hear a click.
4. Make sure that the latches snap in place
correctly.
To start the product
1. Push and hold the power button (A) until the
green LED light (B) comes on.
B
2125 - 005 - 14.01.2025
Only use Husqvarna
A
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the power button until the
green LED light comes off.
3. Remove the battery from the product. Push
the two release buttons and pull out the
battery.
To set the optimal airflow for your work
1. Push the power trigger and hold it at the
optimal airflow for your work.
2. Push the cruise control button to set the
selected airflow. The LED comes on.
13
Publicité
