Publicité
Safety instructions for maintenance
WARNING:
warning instructions that follow before
you do maintenance on the product.
•
Remove the battery before you do
maintenance, other checks or assemble the
product.
•
The operator must only do the maintenance
and servicing shown in this operator's
manual. Speak to your servicing dealer
for maintenance and servicing of a larger
extension.
•
Keep all nuts, bolts and screws tight to be
sure the product is in safe working condition.
Introduction
This section describes how to assemble and
adjust the product.
WARNING:
the product, read the safety chapter
and the assembly instructions.
To assemble the blower tubes
Note:
Apply water-based lubricant on the end of
the tubes to make assembly easier.
•
Attach the lower tube to the upper tube until
the tab (B) goes into the hole (A). Make sure
that the lower tube and the upper tube are
locked together.
A
2125 - 005 - 14.01.2025
Read the
Assembly
Before you assemble
B
•
Replace worn or damaged parts.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk
of accidents.
•
Special training is necessary for all servicing
and repair work, especially for the safety
devices on the product. If not all checks
in this operator's manual are approved after
maintenance, speak to your servicing dealer.
We guarantee that there are professional
repairs and servicing available for your
product.
•
Only use original spare parts.
SAVE THESE
INSTRUCTIONS
•
For higher air speed, attach the high speed
nozzle to the lower tube.
To attach the scraper tool
The scraper tool can be used to loosen leaves
and other unwanted material for easier cleaning.
•
Attach the scraper tool to the lower tube until
the tab (A) goes into the hole (B). Make sure
that the scraper tool and the tube are locked
together.
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery
charger to the wall. An electric
screwdriver can cause damage to the
battery charger.
B
A
Do not use an electric
11
Publicité
