Publicité
C
Useful information
Problems
The machine vibrates
or makes noises.
Water is leaking from
the bottom of the
washing machine.
The machine
stopped just after
the programme was
started.
The machine directly
drains the water it
takes in.
No water is visible in
the machine during
washing.
The door does not
open.
Possible causes / Solutions
• The machine may not be levelled
correctly.
• A solid substance may have
become caught in the pump filter.
• The safety screws for transport
have not been removed.
• The amount of laundry in the
machine may be too small.
• They machine may have been
overloaded with laundry.
• Check that the machine is not
resting on a solid object.
• The drain hose may be clogged
or bent.
• The pump filter is clogged.
Make sure that the washing
machine has not stopped
temporarily due to low voltage.
The height of the drain hose is not
correct.
The water level is not visible from
outside the machine.
• The door lock is activated due to
the water level in the machine.
• The machine is heating the water
or is in the spin cycle.
• The Child Lock mode is activated.
The door lock will be deactivated
two minutes after the end of the
programme.
• The loading door must be blocked
because of the pressure applied
to it.
• The loading door cannot open if
there is no power supply.
41
• Adjust the legs to level the
machine.
• Clean the pump filter.
• Remove the transport safety
screws.
• Put more laundry into the
machine.
• Remove some laundry from the
machine or spread it out manually
to balance it evenly in the machine.
• Make sure the machine is not
placed on any objects.
• Clean or straighten the hose.
• Clean the pump filter.
The machine can resume when the
voltage returns to normal.
Connect the drain hose as indicated
in the manual.
This is not a problem in any way.
• Drain the water from the machine
by starting the Pump or Spin
programme.
• Wait for the programme to finish.
• Wait two minutes for the door lock
to be deactivated.
• Take the handle, push and pull the
loading door to release it and then
open it.
• To open the loading door, remove
the cap from the pump filter
and push the emergency handle
located behind the cap. Refer to the
"Locking the loading door" section.
EN
Publicité
