Télécharger Imprimer la page

VALBERG WF812CW205T Consignes D'utilisation page 47

Publicité

C
Troubleshooting tips
Before calling a technician
You may not need to call a technician if you consult the tables on the following pages.
Problems
The programme does
not start after the door
is closed.
Cannot start or select
the programme.
Water in the machine.
The machine goes into
standby mode after the
programme has been
started or does not
suck up the water.
The machine does not
drain the water.
Useful information
• You did not press the Start /
Pause / Cancel button.
• If you overload the machine, it
will be difficult to close the loading
door.
The machine has gone into safety
mode due to problems with the
power supply (circuit voltage, water
pressure, etc.).
Water may remain in your machine
as a result of quality assurance
procedures carried out during
production.
• The tap is turned off.
• The water inlet hose is bent.
• The water inlet hose is clogged.
• The door may be open.
• The water supply may have been
connected incorrectly or cut off
(when the water supply is cut off,
the cleaning or rinsing indicator
lights will flash).
• The drain hose may be clogged
or bent.
• The pump filter is clogged.
40
Possible causes / Solutions
• *Press the Start / Pause / Cancel
button.
• Reduce the quantity of laundry
and make sure that the loading door
is properly closed.
To cancel a programme, use the
programme selector to choose
another programme. The previous
programme will be cancelled.
(See "Cancelling the programme"
section).
This is not a problem and does not
affect your machine in any way.
• Turn on the taps.
• Straighten the hose.
• Clear the filter.
• Close the door.
• Check the water connection. If the
water supply is cut off, press the
Start/Pause button after the water
supply has been restored to restart
from standby mode.
• Clean or straighten the hose.
• Clean the pump filter.
EN

Publicité

loading

Ce manuel est également adapté pour:

971313