Publicité
Check that your servos are not mechanically obstructed at any point in their full
•
travel.
Dry cells and rechargeable batteries must never be short-circuited - fire hazard.
•
Remove the rechargeable battery if the model is to be transported, or will not be
•
used for a long period.
Do not subject the model to high levels of humidity, heat, cold or dirt.
•
Secure the model and your RC equipment carefully when transporting them.
•
They may be seriously damaged if they are free to slide about.
Pre-flight checks
Before every flying session check that all the radio control functions are working
properly, and carry out a range check: for 35 MHz systems this means fitting the
transmitter aerial and extending it to full length. Switch the transmitter on, followed by
the receiver. Walk away from the model and check at an appropriate distance that all
the controls work properly, and that the control surfaces deflect in the correct "sense"
(direction) relative to the stick movements. If you are using a 2.4 GHz system the
range check is carried out using a special mode which varies from system to system.
Repeat the check with the motor running, while a friend holds the model securely.
If you are flying a model aircraft for the first time we strongly recommend that you ask
an experienced modeller to check the aeroplane first and be ready to help you during
the first few flights.
Care and maintenance
• The model should be cleaned after every session. Remove all traces of dirt from
the propeller. The model and RC system components should be cleaned using
suitable cleaning agents only; please ask your model shop for advice on this.
• If the model will not be flown for a protracted period, clean and re-lubricate all the
moving parts.
Installation notes
• Before installing the system it is essential to read right through these instructions.
• Please be aware of the hazards involved in the use of tools.
• All cables employed must be suitable for the currents which will flow when the
system is in operation.
• Deploy the receiver aerial as far away as possible (at least 3 cm) from high-
current cables.
The following items are required to operate the system:
For Order No. 6098
Speed controller, Order No. 7228
Flight battery, Order No. 7663.3 (2 off)
Extend battery, Order No. 7625.3
Switch harness, Order No. 3934.4
Flap hinge, pack of 2, Order No. 3665.3
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
For Order No. 6097
Speed controller, Order No. 7236
Flight battery, Order No. 7663.3
Extend battery, Order No. 7625.3
Switch harness, Order No. 3934.4
Flap hinge, pack of 2, Order No. 3665.3
18
12/2009
Publicité
