Publicité
Sewing was started with no fabric under the presser foot.
Possible cause:
Place fabric under foot, making sure that needle comes down into fabric; lightly hold both thread tails for first
Solution:
few stitches.
Stabilizer may be needed for technique.
Possible cause:
Place stabilizer underneath fabric.
Solution:
Upper Thread Breaking
Possible cause:
Thread path obstructed
Check if thread is caught on thread spool (rough spots on the spool itself) or behind spool pin or spool cap (if
Solution:
the thread has fallen behind the spool cap and therefore cannot feed freely through the machine path).
Possible cause:
Machine is not threaded correctly.
Remove upper thread completely, raise presser foot lifter, rethread machine making sure thread is in take-up
Solution:
lever (raise take up lever to its highest position by turning hand wheel toward you.
Possible cause:
Upper tension too tight.
Solution:
Reduce upper thread tension.
Technical Specification
Sewing Speed
Maximum 1000 ± 100 rpm
(using straight stitch with default stitch length)
Protection Class
II (Europe)
Type of Lamp
LED light
28 – M aintenance
Rated Voltage
240 V/50Hz, 230 V/50Hz, 220 V/
50-60Hz, 127 V/60 Hz, 120 V/60 Hz,
100V/50-60Hz, 120V/60Hz
Stitch Width
0–6.0mm
Machine Dimensions
Length: ≈450mm
Width: ≈197mm
Height: ≈281mm
Presser Foot Rise Height
6.5mm
Stitch Length
0–4.5mm
Weight
6.6kg
Publicité
