Publicité
Change the Presser Foot
1. Make sure that the needle is in the highest position and the
presser foot is lifted. The presser foot release button extends
out the back of the presser foot holder. Press this button to
release the presser foot.
2. To attach a presser foot to the holder, place the desired presser
foot with its pin directly under the slot in the presser foot
holder. Lower the presser foot lifter and the presser foot
will snap into place.
Note: If you find it difficult to place the presser foot in the
correct position, keep the release button pressed while lowe-
ring the presser foot. Use your thumb to carefully guide the
presser foot into the correct position and it will snap into
place.
Attaching the Edge/Quilting Guide
Attach the edge/quilting guide in the slot (A) as illustrated.
Adjust as needed for hems, pleats, quilting, etc.
Turn power switch to off ("O") when carrying out any
of the above operations!
14 – P reparations
1
2
A
Publicité
