Snuza HERO Guide De Démarrage Rapide page 6

3.4 After three Pre-Alert Notification with Vibration occurences, the Repeated
Pre-Alert Notification will be activated (red flash and beeps every
2 seconds). This feature can be deactivated, see 8.2 of the user manual.
3.5 If the period of no movement detected reaches 20 seconds, an audible
alarm will sound and the Alarm Indicator Light (4) will flash red. The
caregiver must check the reason for no movement detected.
3.6 The Slow Movement Notification alerts you if detected movement rate
slows down. It is identified by the Movement Indicator Light (3) flashing
yellow with a simultaneous dual-tone audible beep every second. This
feature is automatically enabled each time Hero
can be deactivated. See section 8.3 of the user manual for more details.
3.7 To turn off, press the 'ON/OFF' and 'MODE/OFF' buttons simultaneously.
To avoid pinching the baby's skin, gently sweep your fingers between the
•
clip and skin after attachment.
Only use the Hero
•
Not suitable for co-sleeping or bed sharing.
•
Movement from external sources such as being pushed in a pram/stroller
•
or travelling in a vehicle or aircraft may be detected by Hero
Hero should not be relied upon where external sources of movement
SE
•
are present.
This movement monitor may not be able to detect life threatening events.
•
DISCLAIMER: ALL SNUZA PRODUCTS ARE SUPPLIED STRICTLY SUBJECT
TO THE TERMS AND CONDITIONS CONTAINED IN THEIR USER MANUALS
AND PUBLISHED BY SNUZA INTERNATIONAL (PTY) LTD AND ITS AFFILIATES
("SNUZA") FROM TIME TO TIME. THIS INCLUDES SNUZA PRODUCTS
THAT ARE SUPPLIED THROUGH THIRD PARTY DISTRIBUTORS, RETAILERS
AND RESELLERS. IN PURCHASING AND/OR USING A SNUZA PRODUCT,
CONSUMERS EXPLICITLY ACCEPT THESE TERMS AND CONDITIONS AND
ACKNOWLEDGE THAT THEIR USE OF SNUZA PRODUCTS IS ENTIRELY AT
THEIR OWN RISK. CONSUMERS ARE SOLELY RESPONSIBLE FOR ENSURING
THAT SUCH USE IS IN ACCORDANCE WITH THE DIRECTIONS PUBLISHED BY
SNUZA FROM TIME TO TIME.
Precautions:
when the baby is in a motionless bed/cot/crib.
SE
ENGLISH
is switched ON, but it
SE
's sensor.
SE