Publicité
Installing the OPT/i TPS 2. NT242 CU 1400i
Preparation
1
2
3
Fit the PC board into the holder as illustrated
5
Installing the
The NT242 PC board is fitted in the area on the upper left of the right-hand side
NT242 PC board
of the device.
1
2
3
Switch off the welding machine and disconnect it from the mains
Remove the left and right side panels from the welding machine
Remove the cable tie from the two-part cable harness
CLICK!
Insert the PC board with holder into the guides in the welding machine
IMPORTANT! Push in PC board as far as it will go. The two clamping noses
must engage in the corresponding openings in the intermediate plate.
Screw on the brass spacer
Secure the PC board using the brass spacer
Tightening torque = 1.2 Nm
4
Slide the PC board to the right and secure in the
holder
CLICK!
English
1
1
11
Publicité
