Cooktop Use; Cooktop Controls; Dual/Triple-Circuit Element - Jenn-Air JED3430GB Guide D'utilisation Et D'entretien

Cooktop Controls

WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
The controls can be set to anywhere between HIGH and LOW.
To Use:
Push in and turn knob to desired heat setting.
Use the following chart as a guide when setting heat levels.
SETTING
High
Med High
Medium High
Med
Medium
Med Low
Medium Low
Low
Dual/Triple Circuit
Elements
Melt
Warm Zone
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Hot Surface Indicator Light
This unit features a Hot Surface Indicator Light. The Hot Surface
Indicator Light will glow as long as any surface cooking area is
too hot to touch, even after the surface cooking area(s) is turned
off.

COOKTOP USE

RECOMMENDED USE
Bring liquid to a boil.
■
Hold a rapid boil.
■
Quickly brown or sear food.
■
Maintain a slow boil.
■
Fry or sauté foods.
■
Cook soups, sauces and
■
gravies.
Stew or steam food.
■
Simmer.
■
Keep cooked foods warm.
■
Home canning.
■
Large-diameter cookware.
■
Large quantities of food.
■
Melt chocolate or butter.
■
Keep cooked foods warm
■
If the cooktop is on when a power failure occurs, the Hot Surface
Indicator Light will remain on after the power is restored to the
cooktop. It will remain on until the cooktop has cooled
completely.
Cooktop On Indicator Light
Each cooktop has a Cooktop On Indicator light. When the control
knob is on, the light will glow.

Dual/Triple-Circuit Element

The dual-size and triple-size elements offer flexibility depending
on the size of the cookware. Single size can be used in the same
way as a regular element. The dual and triple sizes combine
single, dual and outer elements, and are recommended for larger
cookware, large quantities of food, and home canning.
Triple Element (on some models)
A
B
A. Single size
B. Dual size
C. Triple size
Dual Element
A
B
A. Single element
B. Dual element
To Use SINGLE:
1. Push in and turn knob from the OFF position to the SINGLE
zone anywhere between MELT and HIGH.
2. Turn knob to OFF when finished.
To Use DUAL and TRIPLE:
1. Push in and turn knob from the OFF position to the DUAL or
TRIPLE zone anywhere between MELT and HIGH.
2. Turn knob to OFF when finished.
C
5