Cooktop Use; Cooktop Controls; Sealed Surface Burners - Jenn-Air JGC2536EB Guide D'utilisation Et D'entretien

Cooktop Controls

WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to HI and will automatically reignite if
the flame is extinguished.
If a cross draft is present, the flame may be affected and some
sparking may occur. This is normal.
Before setting a control knob, place filled cookware on the
grate. Do not operate a burner using empty cookware or
without cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to HI.
2. Turn knob to anywhere between HI and LO. Use the
following chart as a guide when setting heat levels.
SETTING RECOMMENDED USE
HI
■
■
■
■
■
Medium
■
Between HI and LO
■
■
■
LO
■
■
Simmer
■
*For a more delicate simmer, see the "Melt Cap" section.

COOKTOP USE

Start food cooking
Bring liquid to a boil
Hold a rapid boil
Quickly brown or sear food
Fry chicken
Maintain a slow boil
Fry or sauté foods
Cook soups, sauces and gravies
Stew or steam food
Simmer*
Keep food warm
Simmer sauces
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Power failure
In case of power failure, the surface burners can be lit manually.
Hold a lit match near a burner and turn knob counterclockwise
to HI. After burner lights, turn knob to setting.
IMPORTANT: Burner reignition feature does not work without
power.

Sealed Surface Burners

A
B
D
C
Standard Burner
A. Cap
B. Spreader
C. Electrode
D. Gas tube opening
Burner installation:
To install the burner base, insert the igniter electrode into the
burner base hole or notch.
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas tube opening: Gas must flow freely throughout the gas
tube opening for the burner to light properly. Keep this area free
of soil and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Keep spillovers out of
gas tube by always using a burner cap.
A
B
D
C
Dual Flame Burner
A. Cap
B. Spreader
C. Electrode
D. Gas tube opening
5