Publicité
1 -
Never launch your kite without being connected to the Life line by the
leash.
You need to connect your kite leash to the loop under the red ball. Connect the
other end of the leash to your harness, at the provided area, usually using a built
in ring located either on the right or the left.
Your leash has a quick release activated by the pulling on the red handle allow-
ing you to completely get disconnected from the kite in case of extreme danger.
Warning, doing so the kite, the bar and lines could hurt some one located under
your wind.
2 - Chicken loop
Place the finger in the harness buckle while you are riding to prevent from
being unhooked.
Warning : if you use a Wichard® release, the F.one release system will not
work. The chicken loop will not go through the Wichard®.
3 - Kite unhooked
You can unscrew the finger to hook and unhook easier. If you let go of your bar
during an unhooked trick, it will run along the Life Line and your kite will land
safely on its back with no power. Pull on the Life Line to retrieve your bar.
Warning, do not add a finger to your harness buckle when using the big loop. If
you active the quick release, the red handle might get stuck in the harness buc-
!
kle because of it.
29
SETTING UP YOUR BAR
ET LA BARRE
Kite leash
www.f-onekites.com
Publicité
