Commissioning - OWIM H13726 Instructions D'utilisation Et Consignes De Sécurité

Commissioning

Weather station – wall mounting:
1. Mark the drill holes (horizontal distance approxi-
mately 11.3 cm) for the weather station and
make sure that no electrical or water lines will be
damaged before drilling the holes (ø 5 mm).
2. Push the dowel into the drilled hole until it is
flush with the wall.
3. Screw the supplied screws into the dowels,
allowing them to protrude slightly for the weather
station to be hung on.
The pre-assembled stand can be removed from the
weather station. Fold the stand downwards and pull
it out of the slot. To attach again, follow the same
procedure in reverse order.
Hanger
Wind gauge assembly:
Choose a suitable location for your wind gauge.
– The wind gauge must be set up outdoors.
– The wind must be able to access the wind
gauge from all sides to enable the wind force
and wind direction to be measured accurately.
– Ensure that the vane and the wind wheel are not
blocked to guarantee accurate measurements.
28 GB/IE
– The wind gauge must be assembled within the
signal transmission range. Walls reduce the
transmission range. Check the signal reception
on the weather station before final assembly.
Ideally, the wind gauge should be mounted on a
mast or roof of a house, where the wind can act
directly on the wind gauge.
A mast is required with a diameter of approx.
25–31 mm (not included) which stands stable and
vertical. Mount the wind gauge as shown below
with the hexagonal socket head bolt, washers,
mounting screws and nuts provided. After assembly,
ensure that the wind gauge is positioned horizon-
tally with a stable hold.
The wind gauge must be positioned horizontally to
guarantee accurate measurements.
Vane
Wind
Hexagonal socket head bolt
wheel
Mounting clamp
Setting up the rain gauge:
Choose a suitable location for the rain gauge.
– The rain gauge must be positioned outdoors.
The device must not be impaired by objects and
obstructions. Do not position under trees or next
to walls.
– The rain must be able to fall on the rain gauge
without obstructions to achieve an accurate
rainfall measurement.
– Ensure that rain water does not accumulate under
the rain gauge. It must be able to flow off freely.
– The rain gauge must be assembled within the
range of the signal transmission. Walls reduce
Mast
Washer
Washer
Nut