Publicité
2. Press the boost button to get the maximum
blade speed. The LED comes on.
3. Release the boost button to use the product
with the initial blade speed.
Automatic shutdown function
The product has an automatic shutdown function
that stops the product if it is not used. The green
LED for start/stop indication goes off and the
product stops after 45 seconds.
Introduction
WARNING:
the safety chapter before you do
maintenance work on the product.
WARNING:
before you do maintenance on the
product.
Maintenance
Clean the external parts of the product.
Examine that the start and stop switch works correctly and is not
damaged.
Make sure that the power trigger and the power trigger lockout func-
tion correctly from a safety point of view.
Make sure that all controls work and are not damaged.
Make sure that the cutter blade and cutter guard have no cracks and
that they are not damaged. Replace the cutter blade or the cutter
guard if they have cracks or if they have been exposed to impact.
Replace the cutter blade if it is bent or damaged.
1777 - 012 - 13.01.2025
Maintenance
Read and understand
Remove the battery
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Press the start/stop button until the green LED
goes out.
3. Press the release buttons on the battery and
remove the battery.
Maintenance schedule
The following is a list of the maintenance steps
that you must do on the product.
Before
Weekly
Monthly
use
X
X
X
X
X
X
15
Publicité
