Publicité
EN
Make settings with the Geberit App
After connecting a Geberit app to the device, the following functions and settings are available:
• Operation:
– Flushing: Actuating a full or partial flush
– Cleaning: Suppressing the flush actuation for a few minutes
• Setting parameters and functions → See Table 3: 'Settings'
• Displaying device information such as the battery charge status or firmware version → See Table 4:
'Information'
• Displaying statistical values for use → See Table 4: 'Information'
• Export of device information and statistical values
• Displaying error messages
• Carrying out firmware updates
• Saving and transferring presettings
The settings can be saved in the Geberit App as presettings and transferred to other devices of the same
type.
Table 3: Settings
Menu item
Operation
[Flush]
[Cleaning]
Name and password
[Name]
[Password]
Commands
[Block flush]
36
Description
Actuates a partial or full flush.
The flush actuation is suppressed
for the [cleaning time]. The LED in
the sensor window flashes every
3 seconds.
[Cleaning time]
A name can be assigned for each
device.
A password can be assigned for
each device.
Flush actuation is blocked for
10 hours. The function can be
stopped early. The function
switches off automatically after
10 hours.
Application
• To carry out function
tests on the lifting
device
• To clean the actuator
plate and the WC
without the water
running
–
• To identify the device
• To protect the device
from unauthorised
access
• To carry out
maintenance work
Value
Factory
setting
On/Off
–
On/Off
–
1–20 min
10 min
–
–
–
–
On/Off
–
27021602280603019 © 09-2024
970.755.00.0(03)
Publicité
