Publicité
HU 1109
PNEUMATIC BRAKE AND CLUTCH BLEEDER
CHARACTERISTICS
Supply tank capacity: chamber air 10L
Supply tank capacity: brake fluid 5L
Max. pressure air tank: 6bar
Max. pressure brake fluid supply tank: 2,5bar
Elastic rubber internal separator membrane
A : 620mm
B : 310mm
C : 240mm
Machines must be transported complete with their
packaging to the area in which they are to be installed.
All lifting and movement of machines or parts transported
separately must be performed by trained personnel.
PRECAUTIONS TO BE TAKEN DURING TRANSPORT AND INSTALLATION
Before being delivered to the ship-ping agent, the material is carefully checked.
Upon receiving the machines check that they have not been damaged during transport or that
the packaging has not been tampered with conse-quent removal of parts from inside.
In the event of damage or missing parts, inform the carrier and manufacturer immediately,
producing photographic
proof.
N.B. It is advisable to check that the supply corresponds to the order specifications.
1 • Open the ball cock (4) and (2), lift and turn the reducer knob (3)
anti-clockwise, then completely release the two tank hemispheres
of all pressure by pressing the bleed valve on the fitting (5A).
2 • Unscrew and remove the filler cap (1), fill the supply tank with at
most 5 litres of fluid, and close and screw down well. Close the cock
(4). Never try to lower the membrane (11) by pressing with pointed
objects (Fig. 3a).
All manuals and user guides at all-guides.com
USE
Publicité
