Publicité
Start-up / Cleaning and care
Start-up
Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control unit
heating pad with the plug-in connector
(see fig. B).
Position the heating pad on your back so that
the fastener for the neck section is in the throat
area.
Then close the fastener.
Then adjust the length of the belt around your
stomach and fit the two ends of the connector
together (see Fig. C) to fasten the belt.
To open the belt, press the two catches on the
connector at the same time (see Fig. C).
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
ting the heating pad for several hours,
20 GB/IE
to the
1
3
to 1, 2, 3, 4, 5 or 6 to
1
illuminates after
2
to 0 to switch off the
1
will switch off.
2
When opera-
we commend setting the control unit
to the lowest setting to prevent
1
overheating and potential burns to the
part of the body heat is applied to.
Temperature levels
Set the required temperature level on the con-
trol unit
(see fig. A).
1
Level 0:
off
Level 1:
minimum heat
Level 2–5: customised heat
Level 6:
maximum heat
Automatic switch-off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
Then select the setting 0 and after about 5 se-
conds, reset the heating pad to the desired
temperature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit
, from the heating pad.
1
Cleaning and care
LIFE BY ELECTRIC SHOCK! Always
remove the mains plug from the socket
and the plug-in connector
unit
from the heating pad (see fig. B) before
1
cleaning the heating pad. Otherwise there is a
risk of electric shock.
2
, i.e. the
3
DANGER TO
with the control
3
Publicité
