Télécharger Imprimer la page

Berner 1003735 Mode D'emploi page 5

Publicité

F. TROUBLE SHOOTING:
Finding
No response when pressing
the switch button.
G. WARNING:
1. Read the instruction manual carefully before using this unit.
2. Jump for 12V vehicles , it would be hazard if used for other jumping.
3. DO NOT use this unit if any cable clamp or cord is damaged.
4. DO NOT use in place of a vehicle battery.
5. DO NOT use as a battery charger.
6. Never remain the unit on car battery after cranking the car success.
7. Make sure to check all the battery connections are CLEAN before Jump Starting! Make sure the
battery clamps are well connected! If the battery terminals on the vehicle are dirty or corroded,
the power of the unit will be lessened.
8. Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating. When
starting up multiple times, each start-up interval is two minutes. Do NOT jump start for more
than 5 seconds. It could damage the unit by overheating.
9. Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it could
lead to damage.
10. Do NOT connect the two clamps together.
11. This appliance must NOT be used unsupervised by children or persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge.
12. Do NOT use as a toy.
13. Do NOT allow the product to become wet.
14. Do NOT immerse the product in water.
15. Do NOT operate the product in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
16. Do NOT modify or disassemble. Only a repair technician may repair this unit.
17. Do NOT expose product to extreme heat or fire.
18. Make sure someone should be within range of your voice or close enough to come to your aid
when working with batteries.
19. Remove personal metal items like rings, bracelets, necklaces, etc. When using the products.
20. Do NOT drop unit. If unit receives a sharp blow or is otherwise damaged in any way have it
checked by a qualified battery technician.
21. Do NOT store in locations where the temperature may exceed 60°C.
22. Charge only at ambient temperature between 0°C and 60°C.
23. Charge only using the charger provided with this unit.
24. Do NOT use the unit to jump start a vehicle while charging the internal battery.
25. If this unit is leaking liquid dispose of at proper recycle facility immediately.
26. Under extreme conditions, battery leakage can occur. If a liquid is noticed coming from product
do not handle with bare hands. In case of skin contact wash with soap and water immediately. If
liquid comes in contact with eyes rinse eyes with cold running water for at least 10 minutes and
get medical attention immediately.
Cause
Low voltage protection of
EPOWER is started.
Remedies
Plug the adaptor into the Quick
Charge input port to activate.

Publicité

loading