2
Move dishwasher close to
cabinet opening
IMPORTANT: Double check correct placement of utilities. Grasp
the sides of the dishwasher at the edges of the door panel. Tilt
dishwasher backwards on wheels and move dishwasher close to
cabinet opening.
NOTE: Do not push on the front of the panel or on the
console–they may dent.
Helpful Tip: Temporarily tape utilities to the floor in the
locations shown to prohibit them from moving when
dishwasher is moved into the cabinet opening.
3
Check water and drain
hose position
Check that water line is on the left side of opening and drain
hose is near the center of the cabinet opening.
4
Open and close door
With another person holding the dishwasher to avoid it from
tipping, open and close the door a few times. If the door closes
or falls open under its own weight, the door tension will need to
be adjusted.
14
All manuals and user guides at all-guides.com
Drain
hose
Direct Wire
only
Water
line
Cable
5
Closes too quickly—
Decrease spring tension
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of
the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
6
Door falls open—
Increase spring tension
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
7
Move dishwasher into
cabinet opening
Insulation
Insulation
blanket
blanket
IMPORTANT: If wheels were removed, avoid damage to the floor
when moving the dishwasher. Slowly move dishwasher
completely into cabinet opening. Do not kink or pinch water line,
drain hose, power supply cord or direct wire between dishwasher
and cabinet. Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket – the blanket reduces the
sound level.
NOTE: If using power cord, make sure to route end through hole
in cutout before sliding into cabinet opening.