Publicité
3
Power Cord—Connect
remaining wires
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Wiring configuration
Power supply wire:
white
black
ground wire
If needed, see website for animated representation of this step.
Visit www.whirlpool.com under FAQ tab.
4
Power Cord—Secure cord
on conduit connector
Tighten strain relief screws to secure cord.
12
All manuals and user guides at all-guides.com
Terminal box wire:
white
black
ground connector
5
Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on
left side of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use ¹⁄₄" nut driver and
previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.
Determine Cabinet Opening
1
Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel position and
the number of turns needed.
Publicité
