Publicité
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
service@pitboss-grills.com | USA: (480) 923-9630 | CANADA (TOLL FREE): 1-877-942-2246
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. CONNECTING THE WHEELS TO THE CART
Parts Required:
1
x
Support Leg /Front (#16-1)
1
x
Support Leg /Back (#16-2)
Wheel (#15)
2
x
Wheel Axle Pin (#G)
2
x
2
x
Wheel Washer (#F)
2
x
Wheel Cotter Pin (#E)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit.
Attach the large Wheel to the Support Leg by inserting the Wheel Axle
Pin through the wheel support leg hole, then secure using the Wheel
Cotter Pin. Repeat installation for the other wheel on same side.
8
ASSEMBLY PREPARATION
ASSEMBLY INSTRUCTIONS
Customer Care for parts.
®
1
16-1
G
G
F
15
15
E
16-2
F
E
Publicité
