Publicité
5. Attach the panel onto the front of the upper frame, attach
the gun holder and cord/hose holder onto the back of the
upper frame, and fasten them with the pairs of screws and
nuts (Fig. 4).
Fig. 4
Nuts
6. Install the foam cannon onto the back of the panel (Fig. 5).
Fig. 5
Panel
7. Fit the spray wand into the trigger gun and rotate the
spray wand until the two parts are completely locked
(Fig. 6).
Fig. 6
Spray wand
8. Connect the high-pressure hose to the trigger gun (Fig. 7).
Panel
Screws
Foam
cannon
Trigger gun
spray wand wings
Fig. 7
Trigger gun
9. Connect the other end of high-pressure hose to the water
outlet of the pressure washer (Fig. 8).
Fig. 8
High-pressure hose
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hose regularly and
replace if damaged. Do not attempt to mend a damaged hose.
10. Thread your garden hose (male end) into the water inlet
(Fig. 9). The garden hose must have an internal
diameter of at least 13 mm (1/2 in.) and must be
reinforced. The water supply must be at least equal to the
washer delivery capacity.
Fig. 9
Water inlet
7
High-pressure hose
Water outlet
Garden hose
Publicité
