Télécharger Imprimer la page

sunjoe SPX4300 Manuel D'utilisation page 13

Nettoyeur haute pression électrique 13 a

Publicité

Troubleshooting
• Disconnect the unit from the electrical power supply before carrying out maintenance on the machine or when checking that
its parts are in proper working order.
• To avoid unnecessary hassles, consult the following table before contacting customer service with any mechanical issues.
Problems
Machine refuses
to start
Fluctuating pressure
• Pump sucking air.
• Valves dirty, worn out, or stuck.
• Pump seals worn out.
Machine stops
Machine pulsating
• Air in inlet hose.
• Inadequate supply of mains water.
• Nozzle partially blocked.
• Water filter blocked.
• Hose kinked.
Machine often starts
and stops by itself
Machine starts, but
no water comes out
Possible Cause
• Power failure/machine not
plugged into a working receptacle.
• Defective socket.
• Defective extension cord.
• Incorrect mains voltage.
• Thermal protection activated.
• Nozzle partially blocked.
• Pump/spray gun is leaking.
• Trigger mechanism is broken.
• Pump/hoses or accessories
frozen.
• No water supply.
• Water inlet filter blocked.
• Nozzle blocked.
Possible Solution
• Check to make sure machine is plugged into
a working outlet.
• Check the power cord and reset the GFCI.
• Try a different outlet.
• Try the unit without an extension cord.
• Check the hoses and connections are airtight.
• Clean or replace valves/seals.
• Please call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
• Check that the mains voltage corresponds to
specification on the model label.
• Let the washer cool down for 5 minutes, then restart.
• Clean the nozzle.
• Allow machine to run by holding the trigger until regular
working pressure resumes.
• Check that the water supply corresponds to the
specification required.
• Clean the nozzle.
• Clean the water inlet filter.
• Straighten out the hose to remove any kinks/blockages.
• Please call the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-
9563) for assistance.
• Wait for pump/hoses or accessories to thaw.
• Connect inlet water.
• Clean the water inlet filter.
• Clean the nozzle.
13
+ Sun Joe
customer service
®
®
+ Sun Joe
customer
®
®

Publicité

loading