Publicité
m
WARNING!
Use only detergents specifically designed
for use with pressure washers, such as Sun Joe
DECK WASH (SPX-HDC1G), Sun Joe
WASH (SPX-FCS1G), or Sun Joe
(SPX-APC1G). DO NOT USE household detergents, acids,
alkaline solutions, bleaches, solvents, flammable material, or
industrial-grade solutions. These could damage the pressure
washer.
1. Remove the foam spray nozzle, fill the foam cannon bottle
with detergent designed specifically for use with pressure
washers, and secure the cap back into place (Fig. 17).
NOTE: Many detergents may require mixing prior to use.
Prepare the cleaning solution as instructed on the solution
bottle.
Fig. 17
Foam
cannon
bottle
2. To connect the foam cannon, pull back the brass Quick-
Connect collar on the spray wand and insert the foam
cannon into the collar. Release the collar and the foam
cannon will click into place (Fig. 18).
Fig. 18
Foam
cannon
3. Turn the foam-volume knob on the foam cannon to vary
the amount of foam (Fig. 19).
4. Turn on the pressure washer. Pull the trigger to operate
the unit. The liquid detergent will automatically mix with
water and be discharged through the nozzle.
HOUSE +
®
SNOW FOAM AUTO
®
HEAVY DUTY CLEANER
®
Pressure
washer
detergent
Spray wand
Fig. 19
5. Apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
6. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
Rinsing with the Pressure Washer
1. Turn off the pressure washer and shut off the water supply.
2. Pull the trigger to release water pressure.
3. Engage the safety lock on the trigger handle by pushing
down on the safety lock on the handle (Fig. 13).
4. Pull back on the Quick-Connect collar and pull out the
foam cannon to release it.
5. Snap the 15º fan-tip nozzle (green) onto the Quick-
Connect collar until it clicks into place (Fig. 16).
6. Start from the top and work your way down, making sure
to overlap your strokes.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline,
oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
10
Foam-
volume
knob
Publicité
