Fog And Mist; Problems - Dovre Vintage 50 Mode D'emploi

1. Open the door of the appliance.
2. Use the scraper to open the ash removal port in
the bottom of the fire compartment (1).
3. Using the scraper, sweep the excess ash (2)
through the ash removal port into the ashtray
underneath.
4. Close the ash removal port.
5. Remove the ashtray (3) using the glove provided
and empty the ashtray.
6. Install the ashtray and close the appliance door.
Comment: The Vintage 30 has no ashtray. Remove
the ash with the aid of a spoon or use an "ash clean
system" on the vacuum cleaner.

Fog and mist

Fog and mist hinder the venting of smoke gases
through the flue. Smoke can precipitate and cause a
stench. If it is not strictly necessary, it is better not to
use the stove with fog and mist.

problems

Refer to the appendix "Diagnostic diagram" to
solve any problems in using the appliance.
Subject to change because of technical improvements
Use
If the appliance does not give off enough heat:
Refer to the appendix "Diagnostic diagram" and
also check whether you are burning enough fuel.
15