Electronic Oven Control; Display/Clock; Starting/Canceling A Function; Indicator Lights - Whirlpool WKP85800 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Display/Clock

When you first plug in the range, "PF" will appear on the
display until you press any command button. If "PF" again
appears on the the display, your electricity was off for a while.
You will need to reset the clock and reprogram any
temperature adjustments you may have made. See "Setting
the Clock" on page 8; and "Adjusting Oven Temperature
Control" on page 12.
When you are using the oven, the display will show preheat
times and temperature settings.
When you are not using the self-cleaning function or cooking
with the oven, the display will show time of day.
When setting a function, if you do not press the START button
within 5 seconds, the START? indicator light will flash. If you
do not press the START button within 5 minutes, the function
will be canceled.

Starting/Canceling a Function

After setting a function for the first time, you must press the
START button to start the function.
The OFF button will cancel any function except the clock, minute
timer, and control lock.

ELECTRONIC OVEN CONTROL

1. Electronic display

Indicator Lights

An indicator light to the left of the display lights up when you are
using an oven function, when the oven door is locked, and when
the oven is on.

Using the Control Lock

The control lock lets you disable the control panel command
buttons. The control lock comes in handy when you want to
prevent others from using the oven.
NOTES :
You can only use the control lock when the oven is not in use
or the control has not been set.
Set the control lock when cleaning the control panel to
prevent yourself from accidentally turning on the oven.
You must reset the control lock if the power goes out for more
than 1 second.
To lock the control panel :
Press and hold the START button for 5 seconds.
You will hear a single tone and "Loc" will appear on the display
for 5 seconds. "Loc" and "START?" will then appear whenever a
command button is pressed.
To unlock the control panel :
Press and hold the START button for 5 seconds.
You will hear a single tone and "Loc" and "START?" will
disappear from the display.
7

Publicité

Table des Matières
loading

Table des Matières