Publicité
• Adjust the height of the handle to the parent's preference (4
positions are possible, see diagram E). Loosen the quick release
uts
clamp of the T-bar handle when adjusting. Tighten the quick release
clamp to secure the T-bar handle after adjustment.
• The parent handlebar can be used to accompany children during
osition
use. Install the footrest (see diagram 1). Place the child's feet on
the footrest and the adult pushes using the parent handle (T-bar).
• Install the patented rear turning module under the deck of the
djusted
scooter. Make sure you securely tighten the knob and engage the
safety lock, in red, located on the knob (see diagram 4a).
• The parent handlebar and the rear turning module can be used to
guide children during use. Place the child's feet on the footrest and
the adult pushes using the parent handle (T-bar).
seat
• Warning! An adult must always hold the parent handle when the
There
child's feet are on the footrest and both hands are on the seat's
rtable
handlebars to avoid the child falling.
• Warning! Make sure to always remove the patented rear turning
module when the product is not used in ride-on mode.
ection
into
Walking bike mode:
of the
• Remove the handlebar tube in the back hole of the seat support
ring
frame.
o
• GO•UP DELUXE LIGHTS 360° SERIES is provided with an
adjustable seat which can be adapted to the child's height (3
top, a
positions). unscrew the knob and slide up/down to adjust the seat
table
height. Align the seat through the screw holes in the seat support
e sure
frame & retighten the knob.
• Warning! Make sure children's feet can touch the ground freely in
port
the seat mode before riding.
Steering: The child pushes with his feet on the floor to advance,
while the child's sitting on the seat. He must proceed with caution at
frame.
first.
upport
d
Notes:
• Always check the body frame is securely inserted to the deck by
pushing downward without lifting up loosely.
• Always check the seat knob is securely tightened.
• To remove the footrest, first release the body frame from the deck
by pressing the PUSH button on the side of the deck, then press
the spring ball on the body frame to release the footrest. (Figure 5)
• A GLOBBER cover is provided to cover the hole behind the seat
while in ride-on mode. This can be mounted onto the T-bar's
column for storage. (Figure 6)
• The footrest can be stored at the seat's back, simply insert this into
the hole behind the seat. (Figure 6)
SCOOTER ASSEMBLY (see page 3-4)
Insert the T-bar column into the integrated tube at the front of the
scooter deck between the two front wheels. Make sure the two spring
balls on either side of the bottom of the column "click" into place for
scooter mode. To release the T-bar or fold/unfold the scooter, step on
the deck with your foot, press the push button on the side of the deck
and pull the T-bar column back at a 30 degree angle. (see diagram
7-12)
GO•UP DELUXE LIGHTS 360° (699) comes with a vibration sensor
LED light module directly integrated in the seat's handlebar:
The different modes are: (Figure 14)
ON: LED lights activated
OFF: LED lights disabled
9
Publicité
