Publicité
Ride-on mode:
• Insert the handlebar tube in the back hole of the seat support
frame. Align the spring-loaded buttons with the notches in the seat
support frame and lock (Figure 4). Double check that the spring-
loaded button is engaged and locked correctly.
• Adjust the height of the handle to the parent's preference (4
positions are possible, see diagram E). Loosen the quick release
clamp of the T-bar handle when adjusting. Tighten the quick release
clamp to secure the T-bar handle after adjustment.
• The parent handlebar can be used to accompany children during
use. Install the footrest (see diagram 1). Place the child's feet on
the footrest and the adult pushes using the parent handle (T-bar).
Walking bike mode:
• Remove the handlebar tube in the back hole of the seat support
frame.
• GO•UP DELUXE is provided with an adjustable seat which can be
adapted to the child's height (3 positions). unscrew the knob and
slide up/down to adjust the seat height. Align the seat through the
screw holes in the seat support frame & retighten the knob.
• Warning! Make sure children's feet can touch the ground freely in
the seat mode before riding.
Steering: The child pushes with his feet on the floor to advance,
while the child's sitting on the seat. He must proceed with caution at
first.
Notes:
• Always check the body frame is securely inserted to the deck by
pushing downward without lifting up loosely.
• Always check the seat knob is securely tightened.
• To remove the footrest, first release the body frame from the deck
by pressing the PUSH button on the side of the deck, then press
the spring ball on the body frame to release the footrest. (Figure 5)
• A GLOBBER cover is provided to cover the hole behind the seat
while in ride-on mode. This can be mounted onto the T-bar's
column for storage. (Figure 6)
• The footrest can be stored at the seat's back, simply insert this into
the hole behind the seat. (Figure 6)
SCOOTER ASSEMBLY (see page 3-4)
Insert the T-bar column into the integrated tube at the front of the
scooter deck between the two front wheels. Make sure the two spring
balls on either side of the bottom of the column "click" into place for
scooter mode. To release the T-bar or fold/unfold the scooter, step on
the deck with your foot, press the push button on the side of the deck
and pull the T-bar column back at a 30 degree angle. (see diagram
7-12)
GO•UP DELUXE PLAY comes with a revolutionary light & sound
LED module directly integrated in the seat's handlebar, with different
modes.
The different modes are: (Figure 14)
ON: Sound & LED lights activated
MUTE: Only LED lights activated
OFF: Both Sound & LED lights disabled
9
Publicité
