Publicité
HOLZMANN Maschinen GmbH
www.holzmann-maschinen.at
Install the two pieces anti-sway bar on
9.
both left and right machine bracket.
10.
Assembly the end stops on the
tracks
Fasten the four end stops (2x38, 39,
40) with screws and nuts (24) to
the ends of the tracks as shown.
11.
Assembly clamping bracket/ stops
Insert clamp (30) into clamp holder and
fix with screw (S1).
Insert long stop (37) on log support and
fix with screw. Insert the short stop (27)
into the holder and also fix it with
screws (S1). The angular position of the
stops on the log support can be
adjusted using the two screws (S2).
12. Control of the sawblade distance. If
this is not identical on the left and
right, it must be adjusted at the
rear handle to either raise or lower
one side.
ASSEMBLY
42
BBS550SMART
Publicité
