Publicité
20
Filters and ERV core washing instructions
For proper maintenance of your energy recovery core please follow these instructions
4
5
7
2
1
3
6
8
10
9
1
Remove the air exhaust filter by sliding it
out.
2
Rotate the metal plate holding the ERV core
and intake air filter in place and remove
filter. Wash filters in warm soapy water
then rinse and let dry.
* When cleaning only the filters, make sure
to replace the metal plate after removing
the filter.
3
Remove the core from the unit.
4
With one of your core's air inlets facing
down, place it in a large sink, bathtub, or
shower.
5
Pour clean tap water through the face of the
core facing upwards until it runs clear.
Ensure the entire surface is rinsed.
6
Rotate the core so that its other air inlet is
facing down and repeat step 5.
7
With plates still oriented vertically allow the
core to dry, normally 2-3 hours.
8
Slide back the core into the system making
sure that the arrow points to the motors.
9
Replace the exhaust air filter.
10 Replace the intake air filter and rotate the
metal plate holding the filter and ERV core
in place.
Publicité
