Operating - marklin 29322 Notice D'utilisation

The feeder track needs the switched mode power
pack to provide power. The switched mode power
pack (1) must therefore be plugged with the cable
(2) into the socket from the feeder track (3).


6.3 Controller
5 – Speed controller
6 – Changing direction
7 – Light button
8 –Address selector switch





7. Operating

7.1 Selecting an address:
(See Section 8 for the appropriate address for
your locomotive.)
Switch Address
• 78
• • 72
• • • 60
• • • • 24

Correct address selected? (See section 8)
Press the desired button.
Braking
* if the locomotive is designed for this
If a short circuit occurs, the switched mode po-
wer pack shuts off and comes back on automati-
cally after the short circuit has been corrected.
7.2 Changing an Address:
If you have 2 locomotives with the same address,
you can change the address for one locomotive
as follows:
Unplug the switched mode power pack and place
only the locomotive to be programmed on the track.
Slide the address selector switch to the desired
address. Press the button "Change Direction". Hold
this button down while you plug the switched mode
power pack back into the household current.
Release the button as soon the light comes on.
The programming procedure is displayed when
the light comes on or blinks. As soon as the light
goes out, the programming is turned off. The loco-
motive can now be run with the new address.
Turning on the
light*
Accelerating
Changing
direction
5