Setting The Clock - Etherma SERENA ECO Instructions D'installation Et D'utilisation

PROGRAM SELECTION
+ + +
- -
JE P1 P2
+ + +
- -
UE P1 P2
+ + +
- -
SA P1 P2
+ + +
- -
dI P1 P2
NOTE: If you do not press the + and - buttons for 15 seconds,
the display returns to its original position, i.e. 19.0.

SETTING THE CLOCK

Set "green continuous light" in Prog mode.
Press the MODE button for 3 seconds to enter the settings
menu. To reset the time, press the MODE button again for 3
seconds.
The day in memory is displayed:
› Change using the + and - keys
› Confirm with the MODE button
The hour in memory is displayed:
› Change using the + and - keys
› Confirm with the MODE button
CALIBRATION OF THE DEVICE AND ROOM TEMPERATURE
In exceptional cases, the temperature in the room may not
match the temperature shown on the display. In such cases
it is possible to adjust the values by entering the actual room
temperature.
This setting can only be carried out if your device is set be-
tween 17 - 23 °C. All doors and windows must be closed.
Wait until the temperature in the room has stabilised (at least
6 hours) and avoid coming and going in the room as much as
possible.
The control thermometer should be placed in the centre of
the room at a height of 1.20 m from the floor. Do not place it
on a piece of furniture.
+
Thursday
- -
= JE
P3 FP
+
Friday
- -
= UE
P3 FP
+
Saturday
- -
= SA
P3 FP
+
Sunday
- -
= dI
P3 FP
Use the + or - buttons Confirm with
to select the preset the MODE
program
Use the + or - buttons Confirm with
to select the preset the MODE
program
Use the + or - buttons Confirm with
to select the preset the MODE
program
Use the + or - buttons Confirm with
to select the preset the MODE
program
Return to the set temperature display.
The minutes in memory are displayed:
› Change using the + and - keys
› Confirm with the MODE button
In the event of a power failure lasting more than 30 minutes,
the time setting for the thermostat is deleted. If it is in pro-
gramming mode and there is a P1, P2 or P3 program on at
least one day of the week, the thermostat shows the user that
the time needs to be set flashing "Hr".
Press the MODE button to switch to "Comfort" mode. Press
the MODE button for 6 seconds. This can be followed by 2
options:
1. Flashing display with "19" = harmonisation is possible
• Change with the + and - keys
• Confirm with the MODE button
2. FF display = harmonisation is not possible
NOTE: If you do not press the + and - buttons for 15 seconds,
the display returns to its original position.
button.
button.
button.
button.
15