Publicité
- Reinstall the bolt and washer. Tighten them securely
4. Cleaning and disinfection
Use a damp cloth with a non-abrasive, non-corrosive product to clean plastic and metal parts.
Do not use cleaning products that could scratch the scooter.
Warning! Please observe the precautions for use of your cleaning product to avoid any risk to your skin or the
scooter's paintwork.
5. Connections
Make sure that the connections are always well connected and that there is no corrosion.
6. ABS plastic
The scooter's bumper is made of very resistant plastic. You can polish it with car wax to keep it shiny.
7. Ball bearings and electric motor
These parts are pre-lubricated and sealed, so they require no maintenance.
8. Console, charger and rear electronics
These parts must be protected from moisture. If these parts are accidentally exposed to wet objects, do not use
the scooter until they are completely dry.
9. Replacing the nylon lock nut
The old nylon locking nut must be replaced with a new one during maintenance, installation and de-installation.
Nylon locknuts are not reusable as they are susceptible to damage, which reduces safety.
- Checklist:
To keep the product in good condition, check before each use, and check regularly as follows:
Check the product
Check freewheel operation
Checking your scooter's speed
Scooter cleanliness
Check the condition of the battery
Check the condition of the tyre cable sheaths
Check that the seat is in the correct position for
use
Check the brakes
Check the condition of the tyres
Version Février 2024
Anytime Weekly
X
X
X
X
X
Monthly
X
X
X
Page 34 sur 53
Publicité
