Publicité
When the scooter's battery becomes weak, the main circuit breaker may trip to protect the motor and electron-
ics from damage. If the circuit breaker trips, the entire electrical system will shut down and the reset button will
appear where shown in the photo.
After tripping, allow the components to cool for 1-2 minutes, then press the reset button to restart the main
circuit breaker. If the circuit-breaker trips frequently, please recharge the battery frequently, and contact the
after-sales service if there is a battery problem.
Note: There is also a fuse in the dashboard to protect its electronic components. If one or more parts of the
dashboard are not responding, check the fuse.
D. Transporting the scooter
When transporting the scooter in a vehicle, ensure that it is properly secured/attached. The photo below shows
in black dots the parts that must be secured/attached/hooked up so that the scooter does not move when the
transport vehicle is in motion.
CAUTION: Do not transport the scooter until it is securely fastened in the vehicle, as this could damage it.
COMFORT SETTINGS
1. Adjusting the height and tilt of the handlebars
To adjust the handlebars on your scooter, first remove the seat (by pulling it upwards) and the seat cover. Then
adjust as shown in the photo:
Caution! Make sure you remove the key from the switch before adjusting the tilt. If your scoo-ter is running,
do not make any adjustments.
Version Février 2024
Page 26 sur 53
Publicité
