Publicité
Front and rear assembly :
Aligning the chassis: Move the front section
closer to the rear section until the hook on
the front section comes into contact with
the spar on the rear section and the lock
engages automatically.
Fitting the seat tube :
Place the tube in the housing and lock it in place using the pin.
Fitting the battery pack :
Present the battery pack as shown below. The battery pack and power supply will connect automatically.
Fitting the seat :
a. Place the seat on the seat tube and rotate it to fix its position.
b. To fit the armrests, insert them into the tube under the seat and lock them in place using the dowel pins, then
secure them using the tightening knobs.
Version Février 2024
Page 22 sur 53
Publicité
