Publicité
1. The Freewheel position lever
You can use this lever to switch the scooter to freewheel mode. Push this lever forward to stop the braking
system. The scooter will then enter freewheel mode. You can now move the scooter with the engine stopped.
Pull the lever back to reactivate the driving and braking systems. The scooter will no longer be in freewheel
mode.
CAUTION Before putting the scooter into freewheel mode, be sure to remove the key from the switch. Do not
sit on the scooter when using this lever. Do not place the scooter on slopes when in freewheel mode.
After using the freewheel mode, remember to return the scooter to the initial position (lever pulled back) to
lock the brake.
2. Electromotor
The electromotor is a device that converts battery power into mechanical energy to drive the scooter's wheels.
3. Anti-rotation system
This system prevents the rear wheels from turning.
CAUTION! UNDER NO CIRCUMSTANCES SHOULD THIS SYSTEM BE REMOVED/DISASSEMBLED.
C. Battery pack
There is a handle at the top of the battery pack, making it easy to remove the battery from the scooter. The
block contains two rechargeable batteries, the charger power input, the overload circuit breaker (reset button)
and the battery fuse. See photo:
To recharge the battery, connect the charger to the scooter (using this power input) and plug it into a mains
socket for 8 to 14 hours:
Version Février 2024
Page 25 sur 53
Publicité
