Publicité
EN
Keep the following tips in mind while setting up the
awning tent:
• The figures provide a general overview of the set-
up. The actual set-up will vary slightly based on the
model of awning tent.
• Get help. The set-up is easier with more people.
• Aer standing the awning tent upright, check
the corner pegs and re-peg if necessary. The
groundsheet on the inside should be taut and in a
rectangular shape.
• Peg the guy lines so that the awning tent is under
tension without distorting the shape.
• If available, attach the storm tie down kit.
• Reguarly check the guy lines to ensure adequate
tension. If necessary, use the runners to adjust.
Set up the awning tent as follows:
1. Unpack the awning tent:
a) To protect the awning tent from dirt and
damage, lay down a groundsheet or footprint
before unpacking.
b) Unpack the awning tent.
Fig.
on page 3
c) Separate and identify the different components.
2. Attach the awning tent to your vehicle using one of
the following methods:
• Throw the 6 m connection straps over the top of
the vehicle and secure them by either pegging
them into the ground or tying them to the
vehicle's wheels.
• Insert the keder into the rail and pull the awning
tent through to the desired location.
• Insert the keder into the cassette awning channel
and pull the awning tent through to the desired
location.
Fig.
on page 3
3. Secure the rear two corners by pegging the
webbing straps about 5 cm under the vehicle.
Fig.
on page 4
4. Inflate the awning tent:
a) Close all deflation valves at the front of the
awning tent.
Fig.
on page 4
b) Unscrew the top cap of the inflation valve.
Fig.
on page 4
c) Insert the pump and inflate the air pole with a
pressure between 3 psi and 4 psi initially.
12
Fig.
on page 5
d) Li the awning tent from either side to help it
take shape.
e) Continue inflating to 9 psi.
f) Remove the pump and secure the top cap of the
inflation valve.
Fig.
on page 5
5. Secure the awning tent:
a) Zip in all panels and close all doors.
Fig.
on page 5
b) Peg the four corners using the adjustable straps.
Fig.
on page 6
c) Peg the orange triangle on either side of the
awning tent (adjust center legs if necessary).
Fig.
on page 6
d) Cross-peg between panels to reduce tension
and ensure smooth zips.
Fig.
on page 6
e) Peg the remaining pegging points on both sides
of the awning tent.
Fig.
on page 7
f) Peg out the quick pitch guy lines.
Fig.
on page 7
g) (Optional) Attach and peg the storm tie down
kit.
Fig.
on page 7
6.4
Dismantling the awning tent
NOTICE! Material damage
Do not use force when dismantling the
awning tent. Otherwise you might damage
any material.
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. If installed, push the canopy pole out of the sleeve,
do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Open the valves on each pole.
8. Wait until most of the air has been expelled.
Publicité
