Publicité
– no re-use. This medical aid is intended for treating one patient only
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material
Fitting instructions
1
Open both diagonal cross restraints and let the restraints hang downwards.
Slip the support with the larger of the two openings (the top) over the foot
first. Put the support on when sitting. Here, the relief zone / function zone (F) should
be at the height of the injured region
Information: The diagonal cross restraint reinforcement is in the calf region. The
front support seam should run centrally along the edge of the calf.
2
On the inner side of the cross restraint, you can see the green inner velour
surface with the directional arrows and marking strips as a so-called "pull
stop". Then, pull the first cross restraint upwards to the desired marking strip (in the
direction of the arrow). Do not exceed the maximum tension shown by the widest,
red marking strip here.
3
Then, place the first cross restraint (in the guide loop) and attach it diagonally
to the lower velour surface using Velcro.
Information: If the velour restraint is too long, you can shorten it by removing the
crocodile fastener. Then, attach the crocodile fastener at the end of the velour.
4
Repeat the process with the second cross restraint. Here, the restraints cross
as an X. It makes no difference which cross restraint you attach first.
5
If required, the circumferential and elastic belt fasteners provided can be
attached to the velour anchors under tensile stress. Ensure that the longer
restraints are attached above and the shorter restraints below.
EN
09
Publicité
